How to solve the irrationality of the slotted crimping wheel of flexo printer slotter die cutter carton machinery

• BOX MAKER
• HIGH GRAPHIC PRINTER VARNISH DRYER
• HIGH SPEED COMPUTERIZED PRINTER
• AUTOMATIC PRE-FEEDER MACHINE

If the slotting and pressing wheel of the flexo printer slotter die cutter carton machinery is unreasonable, it may lead to the physical properties and molding effect of the carton being affected. In order to solve this problem, the following measures can be taken:

1, check the structure of the crimping wheel and adjust it if necessary. You can appropriately increase the step transition arc radius of the crimping wheel to improve the crimping effect.

2, in the formal pressure line before the pre-pressure damage, but need to pay attention to this way may form a more obvious pressure line traces.

3, to ensure that the quality of the original paper should be good, for the higher requirements of the cardboard, should be used to better quality of the surface paper and lining paper.

4, appropriate control of the depth of the pressure line, according to the thickness of the cardboard processed to adjust the gap between the upper and lower pressure line wheel, so that the cardboard can get the appropriate pressure line.

5, keep the moisture content of the raw paper and cardboard in the appropriate range, because the poorer the quality of the raw paper, the drier the cardboard, the higher the chance of crimping rupture.

In addition, the following points should be noted:

1, if the gap between the upper and lower crimping wheels is too large, it should be adjusted.

2、If the glue surface of the crimping rubber wheel is worn, soft, oval or with grooves in the middle, the rubber felt of the crimping wheel should be replaced or re-wrapped, and attention should be paid to the roundness of the glue surface to be good, and there should not be any oval condition.

3、If the cardboard strength is high or in the high speed operation of the machine pressure wheel shaft strength is not enough to bend, you should reduce the start-up running speed or replace the new shaft.

4, if the shape of the wire cutter of the pressure wire wheel does not meet the demand, the applicable molding wire wheel should be replaced.

Solving the problem of irrationality of flexo printer slotter die cutter carton machinery slotting press wire wheel requires comprehensive consideration of a number of factors, including the structure of the press wire wheel, the quality of the original paper and cardboard, the depth of the press wire, and the shape of the wire cutter of the press wire wheel. By taking appropriate measures and adjustments, the molding effect of the carton can be improved and its physical properties can be enhanced.